Next: MONICA
Up: CAMON
Previous: CAMON
Contents
Index
CAMON can be started from a XBONES terminal by:
camon
If you are running ASSISTANCE from a terminal, and want CAMON instead,
enter the command ASSISTANCE
camon to start CAMON. Enter
the command CAMON
exit to get back to ASSISTANCE.
To display a particular CAMON page you simply type
| CAMON /xxxxxxx |
| ie. a forward slash followed by the
name of the CAMON page. |
|
Where the supported pages are listed
.
Fields in error are indicated in reverse video. Investigate any error
that persists for more than a few minutes. Any error has the potential
to corrupt your data. Wait for a scan to proceed for at least one
minute before you become suspicious of sampler level or tracking
errors. After any action, you must wait for the CAMON screen to
refresh three or four times before you can expect the action to take
effect.
Note that any condition that causes the CAMON terminal to emit an
alarm deserves immediate attention. If the problem is a weather alert
(high wind or electrical storm), you must stop observing and
stow the antennas immediately.
The print command can be used in CAMON to print the currently
displayed page to the laser printer, this can be useful for documenting
failures. Refer to the Troubleshooting Section
for advice on how to deal with problems revealed by CAMON.
Next: MONICA
Up: CAMON
Previous: CAMON
Contents
Index
Robin Wark
2006-10-24