List of Figures

1. Five of the antennas in the 122m array
2. Line map of the Control Building's first floor.
3. Azimuth-Elevation diagram for the ATCA.
4. Wrap limits for Compact Array and Mopra antennas
5. PMON antenna alarm cards
6. A typical CAOBS screen display.
7. The CACOR gui display.
8. The CAMON /samp page displaying the sampler levels, the current attenuator levels and the gated total power for the array, when just the first frequency is being used.
9. A typical VIS screen display during setup with CACAL.
10. An example of drivemon display with ACC on antenna 4 crashed
11. An example of a VIS display with an Early/Normal problem (i.e., delay jumps of 8ns).
12. XBONES-ACC Communications: the ACCs are in the antennas, the other tasks run on xbones.
13. An example of drivemon display
14. A typical CAOBS display.
15. The main CACOR screen.
16. A lag spectrum display for a 128MHz bandwidth observation of a strong source.
17. A lag spectrum display for an 8MHz bandwidth observation of a weak calibrator source.
18. Power spectrum of an HI source. Observations by B.Koribalski.
19. Example of an ASSISTANCE display showing the ATCA working normally.
20. The default CAMON (/array) page.
21. Example of a VIS uv display.
22. The CATIE screen.
23. East-West Elevation and Shadowing Limits for the ATCA.
24. H214 Array Elevation and Shadowing Limits.
25. H168 Array Elevation and Shadowing Limits.
26. H75 Array Elevation and Shadowing Limits.
27. Flux density measurements of 1934-638, with 3rd order polynomial fit.
28. Radio frequency interference at 20, 13, 6 and 3cm at the Compact Array in September, 2006
29. Radio frequency interference at 20, 13, 6 and 3cm at the Compact Array in April, 2004
30. Example of a XY products with early/normal problem in 6A or 6B.
31. Example of a poor early/normal calibration.
32. Example of a vis delay plot during early/normal calibration.